Day: July 18, 2022

Let’s take a look at how to install the mixing cylinder of the 9029 machine Let’s install the solvent pump first, Get it on first:

If you want to install a mixer cylinder installation, there are some considerations we would like to talk about, This is called an ink silo:

There are two screws in front of this one, and we’ll take them off:

If we’re going to take it down, we’re going to have to take the four screws off first:

Remove these two screws and be careful not to lose them: 

The machine sometimes reported not detected ink wire or high-pressure fault, did not detect ink wire indicates that the nozzle is blocked, nozzle if blocked,

Take a look at how the power supply is disassembled, First remove the screws around the lid, and then remove the lid:

We turn off the machine, shut it down, unplug it directly, and then we remove the filter:

Click on “Tools”:

If there is no flight time or no jet speed or a bad point split, we can use a magnifying glass to see how the

After unblocking the ink supply, cleaning and recycling tubes, the pipe in the front part of the nozzle is cleared, and then we unblock the

Part of the ink wire enters the recycling tank and is then recycled through the recycling tube:

If this solenoid valve on the spray head breaks down and needs to be replaced, this is the end of the solenoid valve:

When replacing the filter, the inkjet printing should be switched off. If you want to replace the main filter, you need to remove the main

Now it’s been taken apart by me：

We unplugged the line installed here：

We click on Password：