Year: 2022

When we remove the nozzle of the 9040 inkjet printer, we must not remove its fixed base, because if you remove it and install it

And then there is the pipe. If we find a place blocked, for example, the recycling pipe is not recycled, then we can pull out

If the ink line is a little bit off, we’ll spin this, and then the nozzle can be adjusted left and right:

Then, the whole recycling module can be replaced. When replacing, you can choose not to remove the short screw, and then remove the remaining two

Let’s see how this nozzle is removed, unscrew the screw:

We click on the password in the main interface:

See how the print head is disassembled, Then we’ll take this off:

We take the consumables off and remove the screws: 

Let’s take a look at how to install the mixing cylinder of the 9029 machine Let’s install the solvent pump first, Get it on first:

If you want to install a mixer cylinder installation, there are some considerations we would like to talk about, This is called an ink silo:

There are two screws in front of this one, and we’ll take them off:

If we’re going to take it down, we’re going to have to take the four screws off first:

Remove these two screws and be careful not to lose them: 

The machine sometimes reported not detected ink wire or high-pressure fault, did not detect ink wire indicates that the nozzle is blocked, nozzle if blocked,

Take a look at how the power supply is disassembled, First remove the screws around the lid, and then remove the lid: