To remove the ink shunt, we first unplug the relevant lines:

The viscometer has two tubes, and we remove this tube:

Let’s install the front baffle first, First install the left side and put it in:

When installing solenoid valves, these holes do not confuse, if installed wrong, will leak ink:

Install the six valves first:

Just blow from above and there will be cleaning fluid down below it, indicating that the pump is clear:

First of all, the ink should come from the pipe on this side of the main ink tank:

On the main interface, we press the wrench key:

First we need to light up the screen. Here’s an open key, press and hold for 3 seconds without releasing, the machine will boot:

Machine parameter adjustment: Look at how the pressure and modulation voltage are adjusted. First press the wrench key:

In the power-on interface, then press the wrench key, enter the primary password, the primary password is SERVICE. Then press and hold the green key

Take a look at how the machine will supply ink for the first time after it is received. Let’s turn on the machine first. If

Let’s put the ink tank here first: