Category: Domino Machines

Let’s put the ink tank here first: Put the solvent tank on this side: Then pour about 1.2 liters of ink into the ink tank,

Let’s show you how to clean the A120 machine and replace its multiple filters. Let’s go into this interface and enter the advanced service password

n the power-on interface, then press the wrench key, enter the primary password, the primary password is SERVICE. Then press and hold the green key

Take a look at how the machine will supply ink for the first time after it is received. Let’s turn on the machine first. If

If it reports a high-voltage fault, let’s first look at whether there is ink on the high-pressure deflection board, if there is ink, we use

We’ll start by checking the charging tank, which has ink on it, and we’ll mainly see if there’s any ink in this gap: If there

First, we enter the advanced password: press the wrench key and then enter the advanced password Advanced Service Password CHAUCER After entering the advanced password,

If there is a high voltage fault: If it reports a high voltage fault, first we check our high voltage deflection plate,Is there anything dirty

There are three possibilities for recycling failures: The first type is nozzle blockage: if the nozzle blockage causes it, we need to clean the nozzle.

First, let’s click on this setting To set it up, let’s click on the wizard below. There is a nozzle cleaning here, which can only

Domino A120 or A220 are both the same, and its meter counting is in encoder mode: use encoder mode and then reach the meter counting

First, remove the ink bottle from the ink, and then break the two fixed cards up, and the ITM can come out. After taking out,

If the fixing screw is loose and the ink line is deviated, the fixing screw can be adjusted. There is a fixed screw here, which

Click on the “Setup”. Click on “Regional”. Select keyboard languages in “Keyboard layout”.

Click on the “Setup”. Click on “Regional”. Select languages in “Language”.

Click on the “New Information”. Enter the information name and click on OK. This information name is the 233. First of all, you should choose

After receiving the machine, there was no ink in the ITM. You need to put the ink, the chip, the solvent is the same, plug

First, the machine must be turned off: Then we unplug the ink tank:   Break the device holding the ITM02 up: This can be pulled

The first is the recovery failure, check whether the ink line is deviated, that is, whether the line ejected by the nozzle is crooked. If

First of all, we put the ink cartridge with the chip on the end, with the label facing outward, and insert it into the RTM:

Click on settings: The setting is the production line configuration mentioned above, and then the second is the global printing setting, which is also mentioned

First let’s take a look at the menu here, let’s take a look at the print optimization: In the printing optimization, the printing delay, inversion,