Category: Imaje

Look at the language. From the top down。How manylanguages are there.

The first one is the status. If it is, we will tick √ because we currently have no faults After we clicked in, it still showed

We need to open this software Let’s open the editing software  Then we create a new one and click on ‘New’ Then select the type of machine we

Let’s test printing before starting spray printing. We can set this to a stopped state And then we’ll take this test Then we take a piece

Click I press it once and it starts flowing, that’s all Pay attention not to wipe the nozzle area with a cloth as it is particularly

If it’s not turned off, let’s stop it first and press this button to stop it readiness Then we can turn it off by clicking

This is a bracket for the nozzle cable Data cable Print head controller Anti-collision device Power line CD and instruction manual This is photoelectric Controller

Firstly, this is the installation of the four corners at the bottom. Just like us, I have already installed it. It’s paired together, install these

First of all, we need to fix the two screws on the side here There are also two screws on the opposite side that need

Click on this menu and then click on Set Language And there are only two languages here, English and Chinese. Normally, the default is always English  

This is a bracket for the nozzle cable Data cable Print head controller Anti-collision device Power line CD and instruction manual photoelectricity Controller bracket, which

Click on “Tools”: There’s a “nozzle maintenance operation” in the tool： Click “OK”： Then, there’s a “through nozzle” and “solvent suction”: If you click “Get

When we remove the nozzle of the 9040 inkjet printer, we must not remove its fixed base, because if you remove it and install it

And then there is the pipe. If we find a place blocked, for example, the recycling pipe is not recycled, then we can pull out

If the ink line is a little bit off, we’ll spin this, and then the nozzle can be adjusted left and right:

Then, the whole recycling module can be replaced. When replacing, you can choose not to remove the short screw, and then remove the remaining two

Let’s see how this nozzle is removed, unscrew the screw:

We click on the password in the main interface:

See how the print head is disassembled, Then we’ll take this off:

We take the consumables off and remove the screws: 

Let’s take a look at how to install the mixing cylinder of the 9029 machine Let’s install the solvent pump first, Get it on first:

If you want to install a mixer cylinder installation, there are some considerations we would like to talk about, This is called an ink silo:

There are two screws in front of this one, and we’ll take them off:

If we’re going to take it down, we’re going to have to take the four screws off first: