Category: Imaje

Remove these two screws and be careful not to lose them: 

The machine sometimes reported not detected ink wire or high-pressure fault, did not detect ink wire indicates that the nozzle is blocked, nozzle if blocked,

Take a look at how the power supply is disassembled, First remove the screws around the lid, and then remove the lid:

We turn off the machine, shut it down, unplug it directly, and then we remove the filter:

Click on “Tools”:

If there is no flight time or no jet speed or a bad point split, we can use a magnifying glass to see how the

After unblocking the ink supply, cleaning and recycling tubes, the pipe in the front part of the nozzle is cleared, and then we unblock the

Part of the ink wire enters the recycling tank and is then recycled through the recycling tube:

If this solenoid valve on the spray head breaks down and needs to be replaced, this is the end of the solenoid valve:

When replacing the filter, the inkjet printing should be switched off. If you want to replace the main filter, you need to remove the main

Now it’s been taken apart by me：

We unplugged the line installed here：

We click on Password：

It will report a lot of warnings, such as the power failure of the nozzle, and a series of failures such as the high ink

Let’s see how the pipe of the pipe of the S8 and 9040 machine that is not used for a long time can be unblocked.

Remove the filter cotton, which is more difficult to remove, and pull it out:

Another problem is that the ink point split is not good, if the ink point split is not good, we open this top cover, and

We look at the common problems, the most common problem is nozzle blockage, ink line deviation, and then how to deal with it? Then we

Now that it’s all been taken apart by me, the 9020 ink core can be divided into three pieces. This is the lid:

Then, if the printing effect is not good or it is a common problem, then we need to look at the parameters:

Remove the screw:

We put all the wires aside and plug the motherboard in directly：