Category: Videojet Machines

Install the sprinkler. The machine has a total of four nozzles, no matter how many nozzles there are, the installation method is the same. Fix

Install the two fixing blocks on it, and install the screws on both sides  

In the disassembly and installation, there are three large pieces, you need to pay attention to the ink core, pay attention to this joint, it

After the Videojet 43s ink is drained, add about 500ml of cleaning solution to it for cleaning, cleaning for about 20 minutes, need to be

1. How to install the ink core Remove this thing first, and then remove the two screws on the side. After removing the part of

Remove the main filter

I. Ink discharge Remove the screw of the ink supply pipe of the printing module of the nozzle, and then put it on the waste

First remove the cover:  

There are four holes in the base for mounting this column:

First select “Main Menu” in the screen and press Enter:

There’s a button under the console, and we press it down:

I. Ink discharge Remove the screw of the ink supply pipe of the printing module of the nozzle, and then put it on the waste

How to install the valve module? First of all, we install the solenoid valve, the washers above the solenoid valve must not be missing:

The adjustment ink line has two directions, one is to the left or right:

In the “Message Parameters”, select “Product Delay”, we can increase or decrease it according to the position of the printed product:

Select “Nozzle Flush” here:

If printing two lines of words will be missing half, we open the nozzle cover, and then find the recycling tank hanging ink, how to

We select a black-and-white picture, open it, take a screenshot of the picture, depending on the size of the image content:

We look at the installation of solenoid valve, installation to see if the solenoid valve washers are missing, must not be missing, otherwise it will

Now we need to install the ink core. Before we assembled the ink core, we need to install the pipe. See if the washers fall

This is the recovery pump:

Let’s install the PBA board first, before installation, the interface between the front and back should be arranged:

Then we install the PC board and the display, which are connected together:

When the machine is initially used, the ink core must be empty. Match the ink and solvent to their respective positions, and then insert them.