Let’s take a look at the boot and shutdown of the CFB 2-UV laser. Because the UV machine has a water tank, we have to open the water tank first. Before opening the water tank, we will check whether our pipe is broken. And our level, look at the level of the water going down, if the level of our water is not in the green range. We must add pure water or distilled water, tap water is not good. Be sure to add purified water or distilled water. Then the tube is checked for folding. If it is folded, it will not circulate and will damage the machine.
Then we can turn on the machine and turn on the water-cooled switch. This is our set point, which is a value we have now. When it is very close, almost equal, we can turn on the machine.
After we opened the water, we checked the pipe for leaks. Behind the machine, and the bucket to see if there is any leakage. If there is no leak, we should turn the machine off, and then connect the leak place to it, see why it will leak, and then wrap it tight.
Turn on the machine switch again, and the machine switch is in the back. Turn on our machine.
Don’t push it down on this urgent stop. Press down the machine is also off state, can not open, but also power.
Then turn the screen on and see if there was a small green dot. If there is a green dot, our machine has been turned on.
And then our light and then it becomes a normal light. Then we can print the information.
For the shutdown, we can always turn off the host first. Turn off our laser device first.
After turning it off, turn off our water-cooled switch and turn it off. This is a machine on and off a process..
