Let’s take a look at the 9550 labeling machine, how to install its label, first we’ll pull aside:
And then we take the label and take it over, and then we have a winding on our side, and the yellow one is. We are the method of our label winding, and we must circle it according to its direction:
If we expand this one, then we shrink it, and then we put the ribbon in it:
Then you can press the line, and then from this to this, and then to the top, we go to the opposite, we remove the label to it, or we pull up, it will come out and the label will come out:
And then we put it with us, and this is the same if we are in a locked state We have to open it, and then we can press it in here:
After pressing it, then, you can’t do it:
Then we rotate, let us rotate the axis, and then we tighten it, tighten it, after we tighten it, we lock it, so we don’t slip:
And then we put it, and we cover it and we lock it, and we cover it, and then we put it ，Lock it up, and then we, with the label, press it down:
This has a note, say we label, must be in our gap, we the sensor, label is inside, we ribbon in the outside, must be in this, from the gap, from the sensor under the gap, and then through, this is particularly important, if we will not, if we installed in the ribbon that column, so we can’t peel:
Let’s take a look at how to install this ribbon, our model it uses internal carbon, which means our carbon inside, inside us, inside called internal carbon, outside called external carbon:
We have to use the internal carbon, and then put our carbon belt, and then put it in our one, press it down, press it tightly:
Then we according to our figure, our side black, black is our carbon belt winding diagram, we must this, and then according to his figure, then we install, then our side, then come over, come over, come over, then we want to come around from this side, then we collect here, then, we press it, put up, then we put it tight, turn down for a while, tight:
Then we should pay attention to this side, our ribbon, must be inside the sensor, can not be inserted into us this, the label this position, they are the label, labels and ribbons on both sides of our sensor, this should pay special attention to, and then our ribbon, so it is installed:
If we install the correct color, then we ribbon this carbon surface, the carbon surface, must be the surface of our label, they are corresponding:
Finally, let me talk about the width of our ribbon, if we have a 107 print head, a 107 print head We can use 55,76,107 ribbons, or 55 to 107 ribbons.
Then the label, then the width of the label is between 40 to 115, then the length is 50-300 mm, I say mm, the length of the label should be 40-115 mm wide, the length is 50-300 mm.
Why is it 50, because our gap width is 50, so we 48 appearance, so we should be 50 at least, otherwise we can not roll the label, our label can not be posted on our box, but can not stick on the product, this should pay special attention to.
Let me say it again, the width of the label should be 40-115 mm, then its length is 50-300 mm, our label is 9550 machine, and a 107 print head, the label size, and a size of our ribbon.
