When the 9232 machine reported the recovery fault alarm.The recovery failure is alarm 2060.We need to take a look at it if we’re recovering the fault alarm.When we go in at this point.
And then click OK.
And then we’re going to look at our value.Recovery value No.If it says 0, we didn’t detect our recovery value.There may be a problem with the recovered value.Is our ink viscosity normal if you look at it.And then there’s the position of the ink line.The ink line means the spray was blocked.No recovery tank is set.The other one is that our nozzle recovery tank is damp.We just cleaned it out.The nozzles or ink lines are punched around the recycling tank.Made a very dirty mess in the recycling trough.It doesn’t measure this value either.I also call the recovery fault alarm.
This treatment means that.Let’s open the nozzle first.Let’s see if there is any dirt here.This piece of the recycling tank is not dirty.If dirty,we need to clean it.After cleaning it,this side must be blow-dry.We can clean it up after.It’s possible that all we have here is solvent ink.Clean everything like we did. Clean it.
After handling, we’ll have some ink in here.And then there’s the residual liquid.In this case, we should definitely blow it dry.Be sure to blow dry the surface.
We can also blow it with our hair dryer.Make sure this part of the recovery tank is dry.So that there would be no warning.This is a recovery failure.Then we clean it up.
After cleaning up.Then we turn it on again.Let’s turn it on again, open the ink.
Let’s see if this value is there.It’s out.That’s all you need.
And if it still doesn’t.Then we have to choose to open the nozzle.And then maybe the solvent inhalation.Both buttons will work.If I don’t get through the nozzle.We just let him get through automatically.Automatic nozzle opening.
So if we inhale it with this solvent.In this case,we’re gonna we’re gonna take the washing pot.Face us in the middle of the nozzle.Jet cleaning agent.Help it recycle.
Then we dry it after cleaning.Blow dry it from the top down.
Blow Dry and then we turn on again.Let’s open the ink line again.If we open the line again,it’s good if this recovery value comes out.That’s okay. Then we’re done.This is a recovery failure.
