Author: Cheef

If you want to replace the service module, it is in the maintenance section. There is a replacement service module here It is now gray

If you want to replace the service module, it is in the maintenance section. There is a replacement service module here It is now gray

If you want to replace the service module, it is in the maintenance section. There is a replacement service module here It is now gray

This is the throat and nozzle: Open the nozzle cover, from left to right are nozzles, high -voltage deflection boards and recycling slots: Cover with

Now is the Arab language, enter the menu first: Find language: You can change the interface language in it：

Select the second folder option: There are selection information, editing information, new information, and selecting new information: You can see a text box and a

First, open the ink lid and the solvent cover. In the ink tank in the ink tank, not less than 500 ml of ink, the

Printing settings can be adjusted here: There are delayed printing and printing width and height, you can adjust it as needed: here: After the adjustment

First switch the language to Arabic, select it in the menu, select the settings and then press to confirm: In the installation configuration: Choose Arabic

This is the white ink machine of Linx7900 that needs maintenance   This is a white ink rendering The machine is now printing normally. Now

buffer Tee fittings 1. Solvent tank 2. Ink tank motherboard Power module After cleaning the ink path, draw out the ink. Then add cleaning solution

Is it not tightened? I feel like the seam is a bit too big. The gasket is different from before Install the gasket in a

Now the ink has been added and the cycle has been running for 20 minutes, and now it is being sprayed with green stripes Take

Now directly start, press the start button for three seconds Then start the machine to see if it works properly

Now this little line is the ink line Now that the position is basically correct, tighten the screws Then clean again, drain the cleaning solution

The nozzle can shake. Don’t tighten the screws slightly, they have a certain schedule If you can’t adjust it to the recycling tank, it means

Machine 17- Test whether the nozzle is unobstructed Spray cleaning solution onto the nozzle using an ear wash ball to check if the nozzle is

Remove the protective cover from the nozzle Now remove the nozzle and perform an ultrasound.There are two screws, let’s gently loosen them Note that there

Now that the ink line is a bit off, let’s remove the nozzle and use ultrasonic ultrasound. If the pipeline is cleaned, 90% of the

Just now I was under some pressure, and I have to fill it myself. And now there’s a shortage of solvents

Now that the cleaning is complete, after changing the filter, I added some cleaning solution and tested it. The nozzle is a bit clogged. Then

Set the pressure to 0 Then remove the nozzle When disassembling the nozzle, be sure not to lose the O-ring. Maintenance Spray Program Flush Cycle

Pull it out， Just pull it out To replace it with a new one, you can screw it on first Insert it directly If the

Install the current limiting tube Try to pound the tube into the inside of the filter as much as possible, and then tighten the nut